|Artwork Wiring Instructions|
Please use this as a guide for wiring your artwork.
1. Use only D-ring or eyehooks and place them as shown by the horizontal red lines. Saw tooth hangers are not acceptable.
2. Use braided picture hanging wire that is heavy enough to support your artwork.
3. Loop the hanging wire through each hook twice, leaving a 2-3 inch tail. Wrap that tail around the long end of the wire like a braid. Use electrical tape to tape the wire ends so that the installers don't stick their fingers with the sharp ends.
4. The hanging wire should be long enough so that its peak will be 1-2 inches from the top center of the frame.
NOTE: There will be a $25.00 charge per artwork that requires the installers to wire the work for hanging. No artwork will be hung if it is not properly wired.
You can also download an Acrobat PDF of these instructions.